Cursor
Use your own Cursor subscription in a Studio.
Use your own Cursor subscription in every Klarety . It works on your code next to Klarety AI and reaches your data through the built-in Klarety MCP, with your own access. Sign in once and it is ready in every .
Before you start
- You need your own Cursor subscription. Use it as Cursor's own terms allow.
- Your must allow Cursor. An Owner or Admin controls this in SettingsWorkspace under AI tools. If it is not allowed, the Studio says "Your workspace does not allow Cursor."
- You need a project you can open. See Create a project.
Connect Cursor
Open a Studio
Open the project and start its Studio. Wait until it shows Running.
Open an AI tool
In the AI tab, select + (Open an AI tool). Until you sign in, Cursor shows Sign in beside its name. Choose Cursor.
Sign in in your own terminal
Cursor starts in your own terminal in the Studio with its usual sign-in. Sign in with your own Cursor account. Nobody else in the Studio sees or types in this terminal.
Start working
Once signed in, ask Cursor to do something in your project.
Or start from Connectors: find Cursor under AI harness, select Connect, and pick a project under Sign in from. Klarety opens that Studio with Cursor ready to sign in.
Check that it worked
- In Connectors, Cursor shows Connected, with "works in all your projects".
- While Cursor runs in one of your Studios, its page shows your Plan usage (how much of your Cursor plan is used, and when it resets). Only you see it, and it comes from Cursor itself, never your account.
- Open Cursor in another project's Studio: it starts without asking you to sign in.
Use it in another project
Cursor runs in one of your projects at a time. If it is open in another of your projects, the Studio says "Cursor is open in another of your projects. Move it here to use it in this one." Move here closes it there and opens it here, still signed in.
If you turned Cursor off for one project, the Studio says so and offers Turn on for this project.
Close, reopen and continue
Closing the Cursor tab does not stop it. Open it again from + to pick up where it left off. Earlier conversations are under AI sessions in the side panel, where you can Continue one.
Disconnect
Disconnect applies everywhere
Disconnecting removes your sign-in from every project and ends it in any open Studio.
Go to SettingsConnected accounts, find Cursor under Your AI tools, and select Disconnect. Your sign-in is deleted from Klarety. You can connect again any time.
